![]() Cut 4 pieces of material to be made into links with grinder or saw. There is another way these have been done and that is to drill and tap a 1/4-20 threaded hole for a set screw to hold bushing in your links. 005 undersize hole so the bushings turn on shaft instead of inside your links produced. With the links the bushings need to be pressed in so you need to find a final size drill bit or end mill that will produce a. It is always a good idea to test drill a scrap piece of metal with several drill bits or end mills. You have to measure your bike and use handbook to produce parts like these.Ģ. That is why no hard measurements can be given for links and other components. Variables like rake of neck, size of front tire and rim used, and distance of the neck from ground vary from bike to bike. Go to the Handbook and use to get what measurements you need for the length of your links. We will show how to make a set of Girder links here but the same process can be used to build other types of links like in Springer rockers.ġ. ![]() This is a write up I was allowed to do under the banner of: The Chopper Builders Handbook Facebook page.īuilding a set of links for a Custom front end is not hard and can be done by any one able to mark out distances and operate a drill press and grinder.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |